Step-by-step directions for gluing inner corners

When completing, the most important problem can be uneven walls as well as the consequent springs on the background. It is also necessary to take into consideration that when the walls are crookedthe joints of wallpaper canvases could invisibly.

After gluing the previous one in the front of the interior corner of the cloth must measure the remaining space. It’s measured from the border of the pasted cloth to the adjoining wall, so the resulting figure is added 10-15 millimeters. When the walls are very curved, then the additional figure could be more.

Cut a strip equivalent to the resulting figure, taking into account the allowance. The surfaces have been treated with adhesive. Based on the type of coating it might be only the wall or surfaces.

The strip is then glued individually using the cut side to the wall. The wallpaper should go on the opposite plane.

In case the glued background is sterile, then you have to make a few modest cuts perpendicular to the folds.

Level or slope on the adjoining wall is a perpendicular line. The distance in the corner is equal to the diameter of the former cut strip, not such as developments.

The surfaces are smeared with adhesive, and then the coat is glued to the wall with the flat side to the line. The cut goes on the adjacent wall.

Protruding corner should be pasted by analogy with an interior, however there are small differences, which also have to be taken into account when working.

Measured the space remaining in the glued background into the adjacent wall. Insert 20-25 millimeters to the got figure.

A section is cut away, considering the additional 20-25 millimeters.

Prior to gluing, the surfaces have been treated with glue.

The even edge has to be glued into the wallpaper fixed on the wall, the own cut facet”goes” to the next plane. If needed, small cuts are made in the place of going to another background, smoothed gidpola.ru and pressed to the wall.

Draw a vertical strip onto the adjacent wall at a distance of just glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is placed on the wall using its flat side to the marked line, going over the border of the already glued strip.

The joints are smeared with glue and ironed with a roller. Following that, the upper layer is trimmed across the ruler and the 2 layers are joined together.